- Consumption: 35 to 40 W/m² per one temperature from 26 to 28 °C about.
- Temperature: important range from 20 to 30 °C.
- Speed: Elevation in 3 to 4jours in function of the used strength.
- Weak clutters: very weak thickness about 0.5 mm,
- length and variable width.
- Produced effects: acted essentially on the substratum by radiance, the temperature of site didn't alter.
- Fiabilité: several equipped cellars already, giving a whole satisfaction to their owner.
MASSALIA heating elements for temperature increase of substratum are connected to low 220 V with sotf heating, allowing the freezing, heating the substratum to 24\'b0C or higher according the thickness, in site within a timescale of 3 to 4 days, minimizing the room temperature increase of the cellar.
An installation of MASSALIA heating elements for temperature increase of substratum lays on an insulating surface if possible Then, substratum sacks can be laid and removed from the elements as many time as required. Besides, MASSALIA elements can easily be easily stocked flat down or rolled up for instance if needed.
MASSALIA heating elements for temperature increase of substratum are delivered in strip form, of 300, 400, 600, 800, 900 or 1200 mm width, from 700 to 6600 mm length, 0.5 mm thickness. Due to its low contact temperature, MASSALIA element will only heat the substratum sacks laid down on it . Therefore, the electric consumption is very low. E lectric links are connected with multiwires cables brazed on the element. Besides, the elements is fully waterproof and so allows the of substratum sacks wattering any risk at all.
MASSALIA heating elements for substratum temperature increase must be regulated in temperature through an external device.
The warranty of MASSALIA heating elements is of 2 years .
Interventions reduced to the minimum.
Very restricted places immobilistion.
Controled and focused temperature increase
CALCULATION OF THE FACILITIES.
After survey, the power to be installed is given according to the temperature and required timescale of increase.
The increase of maximum temperature is then calculated according to the power and the volume to heated.
SETTING UP:
Must be achieved by a qualified compagny according up to date norms and legislation.
DESCRIPTION OF THE LAYING.
Lay insulators flat down and fix it if necessary.
MASSALIA heating elements are laid flat down only, on the insulating surface .
Heating elements are linked together through a waterproof switchbox and connected to the sector via cable.
General protection throught a switch or differential cutout 30 mAmp per slice of 7.5 kW in mono and of 13 kW in tetra.
Then the substance to be heated can be laid on this heating surface.